Shopping Cart

We ship our products worldwide within 24 hours after your purchase.

Growkit Instructions

Growing with our growkits is super easy. Thanks to a fully colonized substrate with no fillers, these kits require absolutely no maintenance. You don’t even have to do much to get your first flush of extra high psilocin. Just follow the steps below and you are guaranteed a bountiful harvest!

Step

1

Remove the kit, plastic bag and paper clip from the box. Remove the lid from the kit. Rinse the lid under running water. You will need it again later so don’t throw it away.

Step

2

Place the kit without a lid in the plastic bag provided. Slide the kit in the bag with the perforated side on top and wrap the rest of the back tight around the kit. The bag is now wrapped around the kit. Because of the perforations you do not need to worrie about air circulation but opening up the bag every day or 2 for some fresh air is okay.

Step

3

From the moment you see small bulbs growing, you can start placing the bag upright. Do not water the bag. The first mushrooms will be visible after about 1 week.

Step

4

Place the kit in an area with enough daylight and in a temperature range between 18 °C and 28 °C. Never place the grow kit in direct sunlight. Although mushrooms will grow at almost any temperature above 15 °C, 23 °C is the ideal temperature for an optimal harvest. Special heat mats are available to guarantee this temperature and to not have to heat the entire room.

Step

5

From this stage, leave the bag a little bit open all the time, so the moisture can evaporate a little. Too much moisture is not good. Your first harvest will be about a week after the first bulbs appear. Be sure to harvest before the first spores start to fall!

Step

6

These kits produce multiple mushroom harvests. To do this, after the first harvest, fill the kit with clean tap water. Known as cold-shock, this process breathes new life into the mycelium and restores sufficient moisture for the mushrooms to grow.

Step

7

Place the lid of the kit back on the kit. Allow the kit to rest for 12 hours. Open a corner of the lid and drain off excess water. From here you can follow the instructions of step 1 again. This process can be repeated several times.

Grow using a heat mat

Place the plastic bag with the Growkit inside on the heat mat. After 2 days, switch off the heat mat and wait until the buds have developed, which in most cases takes between 5 and 10 days. Then switch the heat mat back on and open the bag slightly from above so that the moisture can evaporate properly.

What to do if after 10 days the buds are still not there

Remove the cake from the plastic container, put it back in the plastic container on its side and start over with 2 days of heat mat on and then off again.

Open chat
Talk to us on WhatsApp!

microdosing.io - logo header

Liever een Nederlandse site?

Leuk dat je op deze site komt kijken, we zien dat je uit Nederland komt dus misschien bekijk je liever onze Nederlandse website.

Klik hier op de NL site te openen.